Pool equipment repair

Equipment is where a good week turns into a bad one, and speed is everything. Because repairs are handled in house by our own service department, your pool gets seen quickly and put right quickly — no waiting in a queue behind another company's schedule while the water goes off.

What we repair

1. Pumps and motors — seals, bearings, impellers, capacitors, and a full replacement when a motor has earned its retirement
2. Filters — cartridge elements, grids, manifolds, pressure gauges and multiport valves
3. Heaters — igniters, pressure switches, thermistors and heat exchangers
4. Valves and plumbing at the pad — diverter valves, check valves, unions and the small leaks that come with age
5. Salt cells and their systems — cleaning, output testing and replacement
6. Controllers, timers and automation — including the boards and actuators behind a schedule that has stopped working

Repair or replace — the straight answer

This is the moment a service company can be genuinely useful. A motor that needs a bearing after ten years has plenty of life left in it, and a rebuild is money well spent. A pump that has already been rebuilt twice is tired metal, and a new one is the better value. We will tell you which of those you are looking at, with the reason, so the decision is yours and it is an informed one.

When a replacement is the right call, we fit variable-speed pumps. They cost a little more up front and a lot less to run, and over a few Texas summers that is where the difference really shows.

Equipment upgrades, large and small

Some pads have simply outgrown themselves — equipment added piece by piece over fifteen years, valves that no longer turn, no room to work. On those we cut the pad out and re-plumb it properly, with quiet variable-speed pumps and full app-controlled automation, sized to your pool instead of to whatever was on the shelf.

The smaller upgrades are just as satisfying: a single valve, a seal, a control board, or the controller that finally makes your schedule make sense. Every job gets the same care, whatever its size.

We usually see it coming

Weekly customers have a real advantage here. We are on the property every week, so we notice the small things early — pressure creeping up, a pump working harder than it should, a heater short-cycling, water where water belongs. Catching those early is how a repair stays a repair.

What we focus on

Weekly service and the equipment on the pad — repairs done in house, and partial or complete equipment upgrades. That focus is why we are quick to the pool and quick with the fix. Building, resurfacing and remodeling belong to the builders, and we are happy to point you to good ones.

Good questions

Do you repair or only replace?

Both, and we will always give you the honest answer for your equipment. A seal and a bearing is a repair well worth doing; a casting that has been rebuilt twice is money better spent on a new pump.

Which brands do you work on?

We install and service Pentair, Jandy and Hayward equipment, which is what most North Texas pools run. If yours is something different, send a photo of the data plate and we will tell you where we stand before you book anything.

Do you do full pad replacements?

Yes — cut out and re-plumb with variable-speed pumps and app-controlled automation. Building, resurfacing and remodeling belong to the builders; the pad is our home ground.

Request a quote All services